Kilt pin bling

[RGM1]

When I initially ordered my kilt outfit, my head wasn't really around the bling aspect of the kilt pin, etc. I ordered a nice variant of the clan Murray kilt pin which I expect to wear most of the time but decided I wanted something a bit more special for dressy occasions. I first acquired a jade bar which at 55 mm seems too delicate before acquiring the jade sword at 75 mm which seems right, however, now I am playing around with the idea of both of them as shown in the picture. Thoughts? The tartan is Murray of Atholl
Jade Kilt Pins smaller.jpg.
Not sure how to rotate picture. Idea is sword vertical with bar below.

I have no association with New Zealand other than finding it a beautiful country when I got to visit.

[Jock Scot]

I know very little about jade, so the question I ask is, how brittle is it? A factor worth consideration. I shouldn't worry too much whether the pin goes with the tartan or not------- it looks fine to me-------- actually though in reality, if you like the pin then wear it. Its that simple.

[RGM1]

Jade is quite hard so I don't think it will break easily under normal use.

[Jock Scot]

Jade is quite hard so I don't think it will break easily under normal use.

Then wear it, if you so wish.

[RGM1]

I reviewed a lengthy thread on kilt pins and picked up a couple of points. Kilt pin acts as a weight on corner of kilt so addition of bar probably helps hold it down. Second, a typical length for a kilt pin is 100 mm and my pin is 75 mm so the bar gives that additional scale. Thanks for feedback.

[Jock Scot]

Just so you know, some people prefer not to have a kilt pin at all and that is perfectly acceptable. Also when the breeze really blows there are not many kilt pins heavy enough to be much help should THE severe gust of wind arrive. If it does arrive and blows the edge of the kilt away and perhaps upwards, nothing will be "on show" as the inner apron will save the day.

In a serious hurricane then you need to watch out as the whole kilt could blow over your head, but that is a very rare event. In the event of the rare serious wind, then holding your arms and hands down by the sides of the kilt....just in case..... is not a bad idea.

I expect you know not to pin the outer apron to the inner apron, but in case you don't, should the outer apron catch on something you could easily tear the kilt apron..

[FossilHunter]

When I initially ordered my kilt outfit, my head wasn't really around the bling aspect of the kilt pin, etc. I ordered a nice variant of the clan Murray kilt pin which I expect to wear most of the time but decided I wanted something a bit more special for dressy occasions. I first acquired a jade bar which at 55 mm seems too delicate before acquiring the jade sword at 75 mm which seems right, however, now I am playing around with the idea of both of them as shown in the picture. Thoughts? The tartan is Murray of Atholl
Jade Kilt Pins smaller.jpg.
Not sure how to rotate picture. Idea is sword vertical with bar below.

I have no association with New Zealand other than finding it a beautiful country when I got to visit.

My personal opinion is to just wear the sword as I feel the two pins together appear cluttered.

Otherwise I think it’s a very cool pin. I’ve always liked the broadsword styled kilt pins you sometimes see.

[PiperPadre]

Thoughts?


My own thoughts are that horizontal pins on a kilt are jarring to the eye. No pin works fine as does one pin. More than one and it gets too busy.