Accomidating a very ample backside :)

[Barb T]

Steve

I can visualize exactly what you're saying, but, even if your kilts ride at the waist, don't you have to make some decisions ahead of time about the taper vs. the pleat length?? If you taper the pleats from the bottom of the fell to the top (which is 2" longer than the measurement), and you cut off an inch, the back will be a different dimension across the top than it would be if you cut off only a half inch across the top (because the pleats taper). Help!

Barb

[The Wizard of BC]

Barb,

You are correct. I knew you would be the one to pick up on that.

If I have a "Gentleman of substance" order a kilt I do a additional quick check when measuring. I call it 'the slope'.

I do all my measurments with a long yardstick and simply put it in the back, record the height, and in the front and record the height. the differance is the slope.

And because I topstitch the 'out pleats' and 'in pleats' before tapering, I can lay out the kilt on the table and draw a rough slope line which I then use as a guide when tapering.

I double check my waist measurments when half of the tapering is done and again just before sewing down the apron edges.

The last sizing check is when sewing down the aprons. If my tapering is off slightly I can adjust on each apron, but this error is usually no more than 1/4" inch. Which means moving each apron closer or further by 1/8". I can live with that.

I'll try to take some photos today and post them so you can better understand.

See, Barb, this is why I want to write the book. I have trouble explaining without pictures and lengthly text. typing in these little boxes just doesn't work for me.

[LordDamax]

Please do I'd love to see exactly what you mean. I get the jist of it... but without pictures, it's hard to, well, picture

[The Wizard of BC]

A bit of clarification,,,,,,,

My last post reads like $*^#

What i was trying to say was---

If you know what the waist measurment is and you know what the hip measurment is, it doesn't matter very much that the pleats in the back are tapered over a longer distance than those on the sides.

To do a quick lay-out check, hand pleat and pin your fabric on your lay-out table. Pin at the hip and also at the top of the taper. Then draw your slope line with chalk.

Now you can adjust the taper so that the measurments at the slope line will be correct for the waist. This will also give you a chance to see how the pattern of the stripes will change and require extra care to get them even, on each side of center.

I assume you will not be trying to create a full hand-sewn kilt. And I assume you are not using Barb's method of pleating and tapering one pleat at a time.
Because this may be one time when laying out all the pleats first is preferable.

[Alan H]

I'm learning a lot from this thread, Barb and Steve and Damax....thanks.