Kilt Pin Locks!!!

[BEEDEE]

Came across this idea while cruising ebay tonight. I know that you can use a piece of rubber on the pin, but these look like a good ides and not too expensive.

Link


Brian

[brandycr]

lol loose a back grab a pencil break off the eraser works till you can do better used to do that alot when id loose a earring back to.

[ccga3359]

Agreed you'll not lose a pin but using an allen key could be quite fiddley. plus there is also the chance of the pin upon coming undone being held pinted directly at the knee just awating the next solid object to impale the wearer. I'm going to pick up some rare earth magnets and modify my XMarks pin and post pictures. Magnets, I believe, are the best alternative.

[Robin]

I use pieces of rubber band...about 1" long

[McMurdo]

Right now I use a rubberband one cut in half does two kilts, I have a bunch of those pin locks I use them for pins on my leather jacket or vest.

[LordKiltClad]

BeeDee check out http://www.pinseller.com

That's from my referral in This Thread

[ChattanCat]

I took a look at the collar and set screw. I would worry about the set screw, it looks like it is steel and may rust. At least for me, I sweat a lot. My brother sweats more, he can beat me to the first drop off the nose every time.:beer:

[neo71665]

BeeDee check out http://www.pinseller.com

That's from my referral in This Thread

I was gonna point that thread out

[McClef]

I mentioned the pinseller locks in an earlier post and included pictures - I don't think you have to worry about them rusting not only because they are not made of iron but also because there is another apron between them on the back of the outer apron and any sweaty bits!