Altering Apron flare

[Bugbear]

Ok, since no one else has posted, I found one of the posts where Barb T. explains this.
http://www.xmarksthescot.com/forum/f...tml#post774499
I'm not crazy!


For some reason I am not able to view a single post on it's own, then link to it any more, so Barb's post is, I think, number 44, and the thread is closed.

Hope that helps.

* It looks like the link goes to the right post.

[Barb T]

Here's the old post, so you don't have to troll through the other one:

First! Your kilt may not need a flare. Check to see whether the apron edge is parallel to a tartan stripe from the top edge to the bottom of the fell (i.e., the stitched part of the left apron edge). If it is straight, parallel to a stripe, then you don't want to press in any flare. If there is some taper at the apron edge in the fell, you can re-press the rest of the edge with a taper.

Set the iron to wool and be sure that the iron has water in it for steam. Lay the kilt on the ironing board, wrong side up. Open up the left apron edge, lay it as flat as you can, and press (don't "iron" - i.e., press down not slide). Once you have taken most of the crease out, flip the kilt over, smooth it out, and lay a damp dish towel or pillow cloth on the tartan, and press again. This will help take that last bit of crease out. I didn't have you use a press cloth on the inside, because I wanted to be sure that you could see exactly what you were doing when you took most of the crease out. You don't want to accidently add a crease.

Let the kilt cool, and put it on. While you are looking straight ahead, have someone pin the edge of the apron where the kilt "wants" to fold. Take the kilt off, and baste a smooth curve along the edge of the apron. Take biggish stitches (1/2" or so), and take the time to do this - don't just skip to the pressing step. Put the kilt back on, and see if you like it. If not, try again. Once you're happy with it, get out the press cloth, and press it in. Just be sure not to muck up the rest of the pleats while you're doing it!

You may have to touch up the new crease with an iron fairly often. Wool can have a persistent memory....