Alterations?

[Steve Ashton]

Almost any competent Tailor should be able to do this simple alteration for you.

You wrap the kilt around yourself without fastening the straps and buckles so the tailor can mark the over lap of the new size.

Then - Un-stitch and remove the buckle, or buckles if there are two, on the right side.
And on the under-apron the strap for the left side.

You then sew these back on at the new size location.

But please remember that hidden under the liner on the inside of the kilt are the floating interfacing which gives the kilt it's vertical stiffness and a strip of fabric called the stabilizer which is like a belt built inside to provide horizontal strength.





When the buckles and strap are sewn back on the stitches MUST pass through the outer Tartan fabric and be anchored to these internal strengthening elements.

If the stitches do no go all the way through or the stitches are made with cotton or a thread that is prone to failure this could be the result.<br>

In this case you can see that the buckles are still in place but were sewn just to the outer Tartan fabric and not anchored to the internal elements and this caused the pleat stitching to fail.

[pageone206]

Thank you for such a helpful and thorough response... with pictures to boot! I did have a question concerning one portion.

Almost any competent Tailor should be able to do this simple alteration for you.

You wrap the kilt around yourself without fastening the straps and buckles so the tailor can mark the over lap of the new size.

Then - Un-stitch and remove the buckle, or buckles if there are two, on the right side.
And on the under-apron the strap for the left side.

You then sew these back on at the new size location.

It seems to me that to maintain visual symmetry on the back of the kilt, one would want to move the buckles only -- on both sides -- and leave the straps where they are. Is there a reason this might not be advisable?

[Father Bill]

Don’t forget that you have the littlle hole through which the strap passes. Since it can’t move, neither must the buckle nearest it.

[pageone206]

Right! I did think of that, but assumed since the buckle would be moving away from the hole, it wouldn't be an issue. I mean, I do realize more of the strap would be visible. In any case, I'm super glad I checked in here before going to a tailor with bad instructions Super appreciate your patience with my inexperience!

[Father Bill]

Inexperienced or not, don't take it to a tailor. Do it yourself unless you're a total doofus.

[Iain Ruaidh]

I've just done my first buckle move. It really is not difficult. You quickly get a feel for bringing the needle back through the fabric in the right place.
I moved the buckles a little bit too far! It works but it's not very pretty. I did remember to see all the way through.

[Steve Ashton]

To answer the question about off-setting the kilt when moving straps and buckles.

If you move the right buckle -

And move the left strap -

The same amount -

Then the kilt will still be balanced.